Yamaha 01V96 Owner's Manual - Page 42
WC IN, INT 44.1k, INT 48k, INT 88.2k, Use the cursor buttons to move the cursor to a source
View all Yamaha 01V96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
42 Chapter 4-Connections and Setup The source select button indicators are explained below: A usable wordclock signal is present at this input, and it is in sync with the current 01V96 internal clock. No wordclock signal is present at this input. A usable wordclock signal is present at this input, but it is out of sync with the current 01V96 internal clock. This input is the currently-selected wordclock source. This input was selected as the wordclock source, but no usable signal was received. Either this input is not receiving wordclock, or else it cannot be used with the currently-installed I/O card. Tip: • The FS box displays the sampling frequency at which the 01V96 is currently operating. • The SLOT TYPE column displays the names of any installed I/O card. • The IN and OUT columns indicate the number of input and output channels available for each installed I/O card. 2 Use the cursor buttons to move the cursor to a source, then press [ENTER]. The following are possible wordclock sources: • SLOT These buttons select the inputs from the digital I/O card installed in the slot as the wordclock source. Inputs are selected in pairs (odd and even numbers in this order). The SLOT TYPE column displays the names of any installed I/O card. The number of pairs depends on the type of I/O card installed. • adat These buttons select the inputs from the ADAT IN connector on the rear panel. Inputs are selected in pairs (odd and even numbers in this order). • WC IN This button selects the wordclock signal input at the WORD CLOCK IN connector on the rear panel. • 2TRD This button selects the 2TR IN DIGITAL input as the wordclock source. • INT 44.1k, INT 48k INT 88.2k, INT 96k ..... These buttons select the internal clock generator as the wordclock source. The 01V96 will function as the wordclock master. Note: To transfer data at higher sampling frequencies (88.2 kHz or 96 kHz) between the 01V96 and connected external devices, you need to set the data transfer format. For more information, see page 72. Tip: If wordclock transfer is interrupted while the 01V96 (being used as a slave unit) is receiving the clock signal, the unit automatically switches to the closest internal clock signal (INT 44.1k, INT 48k, INT 88.2k, or INT 96k). 01V96-Owner's Manual