Yamaha 01V96 Owner's Manual - Page 89

Setting the Input Channels from the Display 89 • ON/OFF button ...........This button turns on or off the currently-selected Input Channel. • Fader This parameter sets the fader position of the currently-selected Input Channel. The fader knob is highlighted when the fader is set to 0.0 dB. Press the [ENTER] button to reset the Fader to 0.0 dB. B SURROUND PAN section • SURROUND PAN........The Surround pan parameters for the currently-selected Input Channel are displayed only when a Surround mode is selected. See page 135 for more information on Surround pan. C BUS ROUTING/FOLLOW PAN section • BUS ROUTING This section enables you to select a destination Bus for the selected channel. When the D button is turned on, the channel signal is patched to the Direct Out selected in the parameter box below the button. (The D button is unavailable for the ST IN Channels.) 7 • FOLLOW PAN This button determines whether the Input Channel's Pan set- ting is applied to the paired Bus Outs (Follow Pan function). When the button is turned off, the Follow Pan function is dis- abled and an identical signal is sent to the paired Bus Outs. Input Channels D AUX section • AUX These controls set the currently-selected Input Channel's Aux Send 1-8 levels and positions. (See page 109 for more information on Aux Sends.) E Meter section • Meters These meters indicate the levels of the currently-selected Input Channel. • PRE EQ/PRE FADER/POST FADER ...........The metering position is displayed below the meters. F GROUP section • FADER/MUTE/EQ/COMP These buttons indicate which Fader, Mute, EQ, or Comp group, if any, the currently-selected Input Channel is in. If the channel is in a group, the group number appears. If the channel is not in a group, "-" appears. (The compressor is unavailable for the ST IN Channels.) 01V96-Owner's Manual