Yamaha 01V96 Owner's Manual - Page 272
FREEZE, ST REVERB, One input, one output basic sampler., Two input, two output stereo reverb.
View all Yamaha 01V96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 272 highlights
272 Appendix A: Parameter Lists FREEZE One input, one output basic sampler. Parameter Range REC MODE MANUAL, INPUT REC DLY -1000 to +1000 ms TRG LVL -60 to 0 dB TRG MASK 0-1000 ms PLY MODE MOMENT, CONTI., INPUT START 1 END 1 LOOP 1 LOOP NUM 0-100 START 2 [SAMPLE] END 2 [SAMPLE] LOOP 2 [SAMPLE] PITCH -12 to +12 semitones FINE -50 to +50 cents MIDI TRG OFF, C1-C6, ALL Description In MANUAL mode, recording is started by pressing the REC and PLAY buttons. In INPUT mode, Record-Ready mode is engaged by pressing the REC button, and actual recording is triggered by the input signal. Recording delay. For plus values, recording starts after the trigger is received. For minus values, recording starts before the trigger is received. Input trigger level (i.e., the signal level required to trigger recording or playback) Once playback has been triggered, subsequent triggers are ignored for the duration of the TRG MASK time. In MOMENT mode, the sample plays only while the that the PLAY button is pressed. In CONT mode, playback continues once the PLAY button has been pressed. The number of times the sample plays is set using the LOOP NUM parameter. In INPUT mode, playback is triggered by the input signal. Playback start point in milliseconds Playback end point in milliseconds Loop start point in milliseconds Number of times the sample plays Playback start point in samples Playback end point in samples Loop start point in samples Playback pitch shift Playback pitch shift fine PLAY button can be triggered by using MIDI Note on/off messages. 1. 0.0~2970.5 ms (fs=44.1 kHz), 0.0~2729.2 ms (fs=48 kHz), 0.0~2970.5 ms (fs=88.2 kHz), 0.0~2729.2 ms (fs=96 kHz) 2. 0~131000 ms (fs=44.1 kHz, 48 kHz), 0~262000 (fs=88.2 kHz, 96 kHz) ST REVERB Two input, two output stereo reverb. Parameter REV TIME REV TYPE INI. DLY HI. RATIO LO. RATIO DIFF. DENSITY E/R BAL. HPF LPF Range Description 0.3-99.0 s Reverb time Hall, Room, Stage, Plate Reverb type 0.0-100.0 ms Initial delay before reverb begins 0.1-1.0 High-frequency reverb time ratio 0.1-2.4 Low-frequency reverb time ratio 0-10 Reverb diffusion (left-right reverb spread) 0-100% Reverb density 0-100% Balance of early reflections and reverb (0% = all reverb, 100% = all early reflections) THRU, 21.2 Hz-8.00 kHz High-pass filter cutoff frequency 50.0 Hz-16.0 kHz, THRU Low-pass filter cutoff frequency 01V96-Owner's Manual