Yamaha 01V96 Owner's Manual - Page 78

78 Chapter 7-Input Channels • ON (On/Off) This section enables you to turn the channel on or off. The channel is muted with the Off setting. • LEVEL This section enables you to adjust the input level of the Input Channel signal. • PAN This section enables you to adjust the pan setting of the signals routed from the Input Channels to the Stereo Bus. You can also apply the pan setting to a pair of Bus channels. • AUX (Aux Send level) This section enables you to adjust the level of signals routed to Aux Sends 1-8. The signals can be routed to Aux Sends from either the pre-fader or post-fader position. • INSERT This section enables you to patch input signals to external devices via the on-board I/O connectors or I/O card, or insert the internal effect processors. You can patch any inputs, outputs, or I/O card channels. (Note that this is different from the INSERT I/O connectors in the AD Input section.) • METER This section enables you to switch the metering position of the signal levels that are displayed in the Meter page. (See page 34 for more information on selecting the metering position.) ST IN Channels 1-4 These stereo channels enable you to process stereo signals using the phase effect, attenuator, and EQ. The following diagram illustrates the ST IN Channel 1-4 signal flow. ST IN 1-4 METER ATT Stereo Configuration 4BAND EQ METER SOLO ON LEVEL PAN PAN LFE PRE/POST ON AUX INPUT PATCH BUS1 BUS2 BUS3 BUS4 BUS5 BUS6 BUS7 BUS8 STEREO L STEREO R SOLO L SOLO R AUX 1 AUX 8 ST IN Channels 1-4 feature the following parameters: • (Phase) • ATT (Attenuator) • 4 BAND EQ (4-band equalizer) • ON (On/Off) • LEVEL • PAN • AUX (Aux Send level) • METER 01V96-Owner's Manual