Yamaha 01V96 Owner's Manual - Page 126
PRE EQ, PRE FADER, Rout1-16 Direct Out, then press [ENTER].
View all Yamaha 01V96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
126 Chapter 10-Input & Output Patching • PRE EQ Immediately before Input Channel EQ • PRE FADER Immediately before Input Channel fader • POST FADER Immediately after Input Channel fader 2 Move the cursor to a patch parameter (1-32) you want to change, then rotate the Parameter wheel or press the [INC]/[DEC] buttons to select the destination. If necessary, specify the signal source position using the DIRECT OUT parameter. 3 Press [ENTER] to confirm the change. Note: If you select a destination that has already been used for an output patch, the patch parameter box indicates "- (no assignment)." If you assign the Direct Out to an unused destination, the parameter box indicates the corresponding output. 4 Press the DISPLAY ACCESS [PAN/ROUTING] button repeatedly until one of the following pages containing the channels you want to patch to the Direct Out appears. • Rout1-16 page This page enables you to change the Input Channel 1-16 rout- ings. • Rout17-STI page.......... This page enables you to change the Input Channels 17-32 and ST IN Channel 1-4 routings. Tip: Refer to page 86 for more information on these pages. 5 Move the cursor to the D button for the channel you want to patch to the Direct Out, then press [ENTER]. The Direct Out patching is now effective, and the signals are routed to the assigned outputs, ADAT OUT channels, or slot output channels. 01V96-Owner's Manual