AMD AMD-K6-2/400 User Guide - Page 120

Preliminary Information AMD-K6™-2E+ Embedded Processor Data Sheet 23542A/0-September 2000 5.7 AP (Address Parity) Pin Attribute Summary Bidirectional AP contains the even parity bit for cache line addresses driven and sampled on A[31:5]. Even parity means that the total number of 1 bits on AP and A[31:5] is even. (A4 and A3 are not used for the generation or checking of address parity because these bits are not required to address a cache line.) AP is driven by the processor during processor-initiated cycles and is sampled by the processor during inquire cycles. If AP does not reflect even parity during an inquire cycle, the processor asserts APCHK # to indicate an address bus parity check. The processor does not take an internal exception as the result of detecting an address bus parity check, and system logic must respond appropriately to the assertion of this signal. Driven, Sampled, and Floated As an Output: The processor drives AP valid off the clock edge on which ADS# is asserted until the clock edge on which NA# or the last expected BRDY# of the cycle is sampled asserted. AP is driven during memory cycles, I/O cycles, special bus cycles, and interrupt acknowledge cycles. The processor continues to drive AP while the bus is idle. As an Input: The processor samples AP during inquire cycles on the clock edge on which EADS# is sampled asserted. The processor floats AP off the clock edge that AHOLD or BOFF # is sampled asserted and off the clock edge that the processor asserts HLDA in recognition of HOLD. The processor resumes driving AP off the clock edge on which the processor samples AHOLD or BOFF # negated and off the clock edge on which the processor negates HLDA. 98 Signal Descriptions Chapter 5