AMD AMD-K6-2/400 User Guide - Page 315
Pin Connection, Requirements, connected to GND through a pulldown resistor.
View all AMD AMD-K6-2/400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 315 highlights
23542A/0-September 2000 Preliminary Information AMD-K6™-2E+ Embedded Processor Data Sheet Pin Connection Requirements For proper operation, the following requirements for signal pin connections must be met: s Do not drive address and data signals into large capacitive loads at high frequencies. If necessary, use buffer chips to drive large capacitive loads. s Leave all NC (no-connect) pins unconnected. s Unused inputs should always be connected to an appropriate signal level. • Active Low inputs that are not being used should be connected to VCC3 through a 20-kW pullup resistor. • Active High inputs that are not being used should be connected to GND through a pulldown resistor. s Reserved signals can be treated in one of the following ways: • As no-connect (NC) pins, in which case these pins are left unconnected • As pins connected to the system logic as defined by the industry-standard Super7 and Socket 7 interface • Any combination of NC and Socket 7 pins s Keep trace lengths to a minimum. Chapter 15 Electrical Data 293