HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 116

4 AUTH-1028 If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1028 Message , [AUTH-1028], ,, ERROR, , Failed to allocate for : port . Probable Cause Indicates that the authentication process failed because the system is low on memory. Data type is the payload or structure that failed to get memory. Operation phase specifies which operation of a particular authentication phase failed. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1029 Message , [AUTH-1029], ,, ERROR, , Failed to get for message: port , retval . Probable Cause Indicates that the authentication process failed to get a particular authentication value at certain phase. Data type is the payload or structure that failed to get memory. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1030 Message Probable Cause , [AUTH-1030], ,, ERROR, , Invalid message code for message: port . Indicates the receiving payload does not have valid message code for a particular authentication phase. 46 Fabric OS Message Reference 53-1001338-01