HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 130

7 BL-1003 Severity CRITICAL BL-1003 Message , [BL-1003], , FFDC, CRITICAL, , Faulting blade in slot . Probable Cause Indicates a faulty blade in the specified slot number. Recommended Action Make sure that the blade is seated correctly. If the blade is seated correctly, restart or power cycle the blade. Run the systemVerification command to verify that blade does not have hardware problems. To run this command root access is required. Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. Refer to the Fabric OS Command Reference for more information on these commands. If the message persists, replace the blade. Severity CRITICAL BL-1004 Message , [BL-1004], , FFDC, CRITICAL, , Suppressing blade fault in slot . Probable Cause Indicates that the specified blade experienced a failure but was not faulted due to a user setting. Recommended Action Restart or power cycle the blade, using the slotPowerOff and slotPowerOn commands. Run the systemVerification command to verify that the blade does not have hardware problems. To run this command root access is required. Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. Refer to the Fabric OS Command Reference for more information on these commands. If the message persists, replace the blade. Severity CRITICAL BL-1006 Message , [BL-1006], ,, INFO, , Blade NOT faulted. Peer blade experienced abrupt failure. Probable Cause Indicates that the errors (mostly synchronization errors) on this blade are harmless. Probably, the standby control processor (CP) blade connected to the active CP blade has experienced transitory problems. Recommended Use the haShow command to verify that the standby CP is healthy. If the standby CP was removed Action or faulted by user intervention, no action is required. Severity INFO 60 Fabric OS Message Reference 53-1001338-01