HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 681

Chapter SYSC System Messages 98 SYSC-1001 Message , [SYSC-1001], , FFDC, CRITICAL, , Failed to run :. Probable Cause Indicates that during the boot sequence, one of the programs does not run on the system. Recommended Action If the message is reported during a restart after new firmware has been loaded, try reloading the firmware using the firmwareDownload command. If the message persists, there might be a conflict between the two versions of firmware or the nonvolatile storage might be corrupted. Run supportFtp (as needed) to set up automatic FTP transfers and run the supportSave command then contact your switch service provider. Severity CRITICAL SYSC-1002 Message , [SYSC-1002], , FFDC, CRITICAL, , Switch bring-up timed out. Probable Cause Indicates the system has timed out during a restart or failover sequence, waiting for one or more programs to register with system services or to fail over to active status. Recommended Action The switch is in an inconsistent state and can be corrected only by a restart or power cycle. Before restarting the chassis, record the firmware version on the switch or control processor (CP) and run the haDump command. If this is a dual-CP switch, then gather the output from the CP in which this log message appeared. Severity CRITICAL SYSC-1003 Message Probable Cause , [SYSC-1003], , FFDC, CRITICAL, , Chassis config option is not supported by CP Blade with ID . Change the chassis configuration Indicates that on system startup, the option configuration file corresponding to the chassisConfig option read could not be found. This indicates that option is not supported on this platform running this version of the firmware. Fabric OS Message Reference 611 53-1001338-01