HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 451

45 HIL-1601 HIL-1601 Message , [HIL-1601], ,, ERROR, , Using backup temperature sensor. Service immediately. Probable Cause Indicates that temperature readings from the primary sensor are out of range. Recommended Action Run the fanShow command to verify that all fans are operating correctly. Replace any deteriorating fan field-replaceable units (FRUs). Run the tempShow command to verify temperature values. If any sensor is too high, monitor the switch. Try rebooting or power cycling the switch. Severity ERROR HIL-1602 Message , [HIL-1602], , FFDC, CRITICAL, , Multiple temperature sensors failed. Service immediately. Probable Cause Indicates that temperature readings from multiple sensors are out of range. Recommended Action Run the fanShow command to verify that all fans are operating correctly. Replace any deteriorating fan field-replaceable units (FRUs). Run the tempShow command to verify temperature values. If any sensor is too high, monitor the switch. Try rebooting or power cycling the switch. Severity CRITICAL HIL-1603 Message , [HIL-1603], , FFDC, CRITICAL, , fans out of service. System is shutting down immediately. Probable Cause Indicates that the total fan failure count is greater than or equal to two. Recommended To avoid causing damage to the switch, the system shuts down automatically. To help prevent Action future problems, make sure that all the fans are working properly. Severity CRITICAL HIL-1610 Message Probable Cause , [HIL-1610], , FFDC, WARNING, , Fan/PS unit not supplying power, fan speeds not available. Please ensure that the unit has power and the switch is on. Indicates that the power supply is not connected to a power source or it is not switched on or the unit is faulty. Applicable only to Brocade 5100. Fabric OS Message Reference 381 53-1001338-01