HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 364

42 FW-1161 Recommended Action Check both ends of your cable connection. Verify that the cable and small form-factor pluggables (SFPs) are not faulty. Losses of synchronization commonly causes link failures. If you receive concurrent loss of synchronization errors, troubleshoot the loss of synchronization. Severity INFO FW-1161 Message , [FW-1161], ,, INFO, , , , is below low boundary(High=, Low=). Current value is . Probable Cause Indicates that the number of link failures that the port experiences has fallen below the low boundary. Link loss errors occur when a link experiences a loss of signal and fails. Both physical and hardware problems can cause link loss errors. Link loss errors frequently occur due to a loss of synchronization. Check for concurrent loss of synchronization errors and, if applicable, troubleshoot them. A low number of link loss errors means that the switch is functioning normally. Recommended No action is required. Respond to this message as is appropriate to the particular policy of the Action end-user installation. Severity INFO FW-1162 Message , [FW-1162], ,, WARNING, , , , is above high boundary(High=, Low=). Current value is . Probable Cause Indicates that the number of link failures that the port experiences has risen above the high boundary. Link loss errors occur when a link experiences a loss of signal and fails. Both physical and hardware problems can cause link loss errors. Link loss errors frequently occur due to a loss of synchronization. Check for concurrent loss of synchronization errors and, if applicable, troubleshoot them. Recommended Action Check both ends of your cable connection. Verify that the cable and small form-factor pluggables (SFPs) are not faulty. Losses of synchronization commonly cause link failures. If you receive concurrent loss of synchronization errors, troubleshoot the loss of synchronization. Severity WARNING FW-1163 Message , [FW-1163], ,, INFO, , , , is between high and low boundaries(High=, Low=). Current value is . 294 Fabric OS Message Reference 53-1001338-01