HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 150

10 BM-1053 Severity INFO BM-1053 Message , [BM-1053], ,, WARNING, , Failed to establish connection between CP and Application Processor. Faulting switch. Probable Cause Indicates the control processor (CP) could not establish a connection with the application processor to communicate. Recommended On the Brocade 7500 or 7600, turn off and turn on all the primary power to power-cycle the unit. Action Severity WARNING BM-1054 Message , [BM-1054], ,, INFO, , AP firmware is not consistent with system firmware . Auto-leveling AP firmware to match system firmware. Probable Cause Indicates the policy of the specified blade is set to auto-level the blade firmware to the system firmware. This may be due to one of the following reasons: • Blade firmware was detected to be different from control processor (CP) firmware due to a firmware upgrade. • The blade was just inserted and had a different firmware loaded. Recommended No action is required. The blade will automatically download the updated firmware. Action Severity INFO BM-1055 Message , [BM-1055], ,, WARNING, , Firmwaredownload timed-out for AP. Faulting switch. Probable Cause Indicates the firmwareDownload command on the application processor (AP) blade failed. Recommended Use the slotPowerOff and slotPowerOn commands or reseat the affected blade. On the Brocade Action DCX, 7500 or 7600, turn off and turn on all primary power in order to power-cycle the unit. Severity WARNING BM-1056 Message , [BM-1056], ,, INFO, , AP is not configured. Persistently disabling all ports on the switch. 80 Fabric OS Message Reference 53-1001338-01