HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 234

24 ESW-1004 DRAFT: BROCADE CONFIDENTIAL ESW-1004 Message , [ESW-1004], ,, ERROR, ,Blade attach failed during recovery, disabling slot = . Probable Cause Indicates that the blade has failed during failover or recovery. Recommended On a Brocade 8000 switch, restart or power cycle the switch. Action Severity ERROR ESW-1005 Message , [ESW-1005], ,, ERROR, ,Diag attach failed during recovery, disabling slot = . Probable Cause Indicates that the Diag blade attach command has failed during failover or recovery. Recommended On a Brocade 8000 switch, restart or power cycle the switch. Action Severity ERROR ESW-1006 Message , [ESW-1006], ,, WARNING, , HA state out of sync: Standby CP (ver = ) does not support NPIV functionality. (active ver = , NPIV devices = ). Probable Cause Indicates that the standby control processor (CP) does not support N_Port ID Virtualization (NPIV) functionality, but the switch has some NPIV devices logged into the fabric. Recommended Load a firmware version on standby that supports NPIV functionality, using the firmwareDOwnload Action command. Severity WARNING ESW-1007 Message , [ESW-1007], ,, WARNING, ,Switch port disabled due to \"\". Probable Cause Indicates that the switch port is disabled due to the reason displayed in the message. Recommended Action Based on the disable reason displayed, take appropriate action to restore the port. Insufficient frame buffers: Reduce the distance or speed settings for the port to reduce the buffer requirement of the link. Alternatively, one or more ports in the port group must be disabled to make more buffers available for the link. Refer to the Fabric OS Administrator's Guide for more information. 164 Fabric OS Message Reference 53-1001338-01