HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 148

10 BM-1004 Recommended Use the slotPowerOff and slotPowerOn commands or reseat the affected blade. Action Severity WARNING BM-1004 Message , [BM-1004], ,, INFO, , Blade firmware on slot is not consistent with system firmware . Auto-leveling blade firmware to match system firmware. Probable Cause Indicates the policy of the specified blade is to auto-level the blade firmware to the system firmware. The reason for the inconsistency may be either of the following: • Blade firmware was detected to be different from the control processor (CP) firmware due to a firmware upgrade. • The blade was just inserted and had a different version of the firmware loaded. Recommended No action is required. The blade will automatically download the updated firmware. Action Severity INFO BM-1005 Message , [BM-1005], ,, WARNING, , Firmwaredownload timed-out for blade in slot . Faulting blade. Probable Cause Indicates the firmwareDownload command failed for the blade in the specified slot. Recommended Use the slotPowerOff and slotPowerOn commands or reseat the affected blade. On the Brocade Action 7500 or 7600, switch off and switch on all primary power to power-cycle the unit. Severity WARNING BM-1006 Message , [BM-1006], ,, INFO, , Blade is not configured. Persistently disabling all ports for blade in slot . Probable Cause Indicates the policy of the specified blade is set to persistently disable all ports the first time the blade is detected. The message indicates either of the following: • The blade was detected in this slot for the first time. • The blade was configured under a different mode. Recommended Configure the blade so that it will persistently enable the ports. Action Severity INFO 78 Fabric OS Message Reference 53-1001338-01