HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 220

22 EM-1033 Probable Cause Indicates that the environmental monitor (EM) has found a switch blade that is inserted, but the ejector switch is not closed. The blade in the specified slot is treated as not inserted. Recommended Action Close the ejector switch (raise the slider in most blades, or completely screw in the upper thumbscrew for the FC4-48 port blade) if the field-replaceable unit (FRU) is intended for use. Refer to the appropriate hardware manual for instructions on inserting the switch blades. Severity ERROR EM-1033 Message , [EM-1033], ,, ERROR, , CP in set to faulty because CP ERROR asserted Probable Cause Indicates that the standby control processor (CP) has been detected as faulty. The High Availability (HA) feature will not be available. This message occurs every time the other CP reboots, even as part of a clean warm failover. In most situations, this message is followed by the EM-1047 message, and no action is required for the CP; however, you might want to find out why the failover occurred. Recommended Action If the standby CP was just rebooted, wait for the error to clear (run slotShow to determine if it has cleared). Watch for the EM-1047 message to verify that this error has cleared. If the standby CP continues to be faulty or if it was not intentionally rebooted, check the error logs on the other CP (using the errDump command) to determine the cause of the error state. Try reseating the field-replaceable unit (FRU). If the message persists, replace the FRU. Severity ERROR EM-1034 Message , [EM-1034], ,, ERROR, , set to faulty, rc=. Probable Cause Indicates that the specified field-replaceable unit (FRU) has been marked as faulty for the specified reason. Recommended Action Try reseating the FRU. Run the systemVerification command to verify that the switch does not have hardware problems. To run this command root access is required. Refer to the Fabric OS Command Reference for more information on this command. If the message persists, replace the FRU. Severity ERROR 150 Fabric OS Message Reference 53-1001338-01