HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 217

22 EM-1013 Probable Cause Indicates that a switch blade or nonbladed switch failed to transition from one state to another. It is faulted. The specific failed target state is displayed in the message. There are serious internal Fabric OS configuration or hardware problems on the switch. Recommended Action On Brocade DCX, 24000 and 48000, try reseating the indicated field-replaceable unit (FRU). If the message persists, restart or power cycle the switch. Run the systemVerification command to verify that the switch does not have hardware problems. To run this command root access is required. Refer to the Fabric OS Command Reference Manual for more information on this command. If the message persists, replace the FRU. Severity CRITICAL EM-1013 Message , [EM-1013], ,, ERROR, , Failed to update FRU information for . Probable Cause Indicates that the environmental monitor (EM) was unable to update the time alive or the original equipment manufacturer (OEM) data in the memory on a field-replaceable unit (FRU). Recommended Action If you ran the fruInfoSet command, try the command again; otherwise, the update is automatically attempted again. If it continues to fail, try reseating the FRU. If the message persists, replace the FRU. Severity ERROR EM-1014 Message , [EM-1014], ,, ERROR, , Unable to read sensor on () Probable Cause Indicates that the environmental monitor was unable to access the sensors on the specified field-replaceable unit (FRU). Recommended Try reseating the FRU. If the message persists, replace the FRU. Action Severity ERROR EM-1015 Message , [EM-1015], ,, WARNING, , Warm recovery failed (). Probable Cause Indicates that a problem was discovered when performing consistency checks during a warm boot. Recommended Monitor the switch. If the problem persists, a reBoot or power cycle is required to resolve the Action problem. Fabric OS Message Reference 147 53-1001338-01