HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 590

90 SEC-1097 Severity ERROR SEC-1097 Message , [SEC-1097], ,, ERROR, , Cannot find policy set. Probable Cause Indicates the specified policy could not be found. Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the Action supportSave command and contact your switch service provider. Severity ERROR SEC-1098 Message , [SEC-1098], ,, ERROR, , No FCS list. Probable Cause Indicates the specified policy could not be found. Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command Action and contact your switch service provider. Severity ERROR SEC-1099 Message , [SEC-1099], ,, ERROR, , Please enable your switch before running secModeEnable. Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1100 Message , [SEC-1100], ,, ERROR, , FCS switch present. Command terminated. 520 Fabric OS Message Reference 53-1001338-01