HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 243

26 FABR-1013 FABR-1013 Message , [FABR-1013], , FFDC, CRITICAL, , No Memory: pid= file= line=. Probable Cause Indicates that there is not enough memory in the switch for the fabric module to allocate. This message is rare and usually indicates a problem with the Fabric OS. Recommended Action The system will recover by failing over to the standby CP. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity CRITICAL FABR-1014 Message , [FABR-1014], , FFDC, ERROR, , Port Disabled: Insistent Domain ID could not be obtained. Principal Assigned Domain ID = Probable Cause Indicates that the specified port received an request domain ID (RDI) accept message containing a principal-switch-assigned domain ID that is different from the insistent domain ID (IDID). Fibre connectivity (FICON) mode requires an insistent domain ID. If an RDI response has a different domain ID, then the port is disabled. Recommended Action Run the configShow command to view the fabric.ididmode. A '0' means the IDID mode is disabled; a '1' means it is enabled. Set the switch to insistent domain ID mode. This mode is set under the configure command or in Web Tools on the Switch Admin > Configure window. Severity ERROR FABR-1015 Message , [FABR-1015], , FFDC, ERROR, , FICON Insistent DID max retry exceeded: All E-Ports will be disabled. Switch is isolated. Probable Cause Indicates that the application exceeded request domain ID (RDI) requests for the insistent domain ID. All E_Ports are disabled, isolating the specified switch from the fabric. Recommended Action Verify that the insistent domain ID is unique in the fabric and then re-enable the E_Ports. Run the fabricShow command to view the domain IDs across the fabric and the configure command to change the insistent domain ID mode. Refer to the Fabric OS Command Reference for more information on these commands. Severity ERROR Fabric OS Message Reference 173 53-1001338-01