HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 713

11 ZONE-1017 ZONE-1017 Message , [ZONE-1017], ,, ERROR, , FA Zone() contains incorrect number of Initiator and Target devices. Probable Cause Indicates the fabric assist (FA) zoning configuration has more than one initiator. The probable cause is incorrect entries in the FA zoning configuration. Recommended Edit the zone database to ensure that only one initiator is set for each FA zone configuration. Action Severity ERROR ZONE-1018 Message , [ZONE-1018], ,, ERROR, , Incorrect zoning enforcement type() at port(). Probable Cause Indicates an incorrect zoning enforcement type was reported on the specified port. This is a software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid. The valid zone type values are: • hard port zone (value = 1) • hard wwn zone (value = 2) • session based hard zoning (value = 3) • FA zone (value = 5) QuickLoop zones are not supported in Fabric OS v4.x and above. Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the Action supportSave command and contact your switch service provider. Severity ERROR ZONE-1019 Message , [ZONE-1019], ,, ERROR, , Transaction Commit failed. Reason code () - \"\" Probable Cause Indicates the reliable commit service (RCS) had a transmit error. RCS is a protocol used to transmit changes to the configuration database within a fabric. Recommended Action Often this message indicates a transitory problem. Wait a few minutes and retry the command. Make sure your changes to the zone database are not overwriting the work of another admin. Run the cfgTransShow command to find out if there is any outstanding transaction running on the local switches. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Fabric OS Message Reference 643 53-1001338-01