HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 222

22 EM-1036 Probable Cause Suggests that since both power supplies associated with one of the two main circuits are present but faulty, maybe the circuit's switch has been turned off, or the AC power source has been interrupted for that circuit. The Switch side value is either "left" or "right" designating which circuit switch, facing the cable side of the chassis. The Switch side value indicates: • left: controls the odd numbered power supply units. • right: controls the even numbered power supply units. Recommended Check that the identified AC circuit switch is turned on, that the power cord is properly attached Action and undamaged, and that the power source is operating properly. Severity ERROR EM-1036 Message , [EM-1036], ,, WARNING, , is not accessible. Probable Cause Indicates that the specified field-replaceable unit (FRU) does not seem to be present on the switch. If the FRU is a world wide name (WWN) card, then default WWN and IP addresses are used for the switch. Recommended Action Reseat the FRU card. If the message persists, reboot or power cycle the switch. Run the systemVerification command to verify that the switch does not have hardware problems. To run this command root access is required. Refer to the Fabric OS Command Reference for more information on this command. If the message persists, replace the FRU. Severity WARNING EM-1037 Message , [EM-1037], ,, INFO, , is no longer faulted. Probable Cause Indicates that the specified power supply has been marked as no longer being faulty, probably because its AC power supply has been turned on. Recommended No action is required. Action Severity INFO 152 Fabric OS Message Reference 53-1001338-01