HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 227

22 EM-1060 Recommended Replace the blade. Make sure the replacement is compatible with your switch type. Action Severity ERROR EM-1060 Message , [EM-1060], ,, WARNING, , Stopping synchronization of the system due to blade incompatibility with software version on standby CP. Probable Cause Indicates a blade in the system is not supported by the release on the standby control processor (CP). Recommended Action Remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken, this CP must be rebooted or the haSyncStart command must be run successfully. Until this is done, the system will remain out of synchronization. Severity WARNING EM-1061 Message , [EM-1061], ,, WARNING, , Synchronization halted. Remove all blades of type or upgrade your standby CP, then reboot or run haSyncStart. Probable Cause Indicates a blade in the system is not supported by the release on the standby control processor (CP). Recommended Action Remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken, this CP must be rebooted or the haSyncStart command must be run successfully. Until this is done, the system will remain out of synchronization. Severity WARNING EM-1062 Message , [EM-1062], ,, CRITICAL, , Blade in slot faulted as it exceeds the maximum support limit of blades with Blade ID in the chassis. Probable Cause Indicates too many blades of a particular type are in the system. Recommended Remove the faulted blade. Action Severity CRITICAL Fabric OS Message Reference 157 53-1001338-01