HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 287

34 FCR-1053 Recommended Action Run the portEnable and portDisable commands to enable and disable the port. If the problem persists contact your switch service provider. Severity ERROR FCR-1053 Message , [FCR-1053], ,, WARNING, , Port was disabled, . Probable Cause Indicates that the specified port was disabled because of a mismatched configuration parameter. Recommended Use the specified disable reason to identify a possible configuration parameter mismatch between Action the EX_Port and the switch at other end of the link. Severity WARNING FCR-1054 Message , [FCR-1054], ,, WARNING, , Port received ILS of incorrect size (); valid ILS size is . Probable Cause Indicates that an internal link service (ILS) IU of invalid size was received from the switch on the other end of the link. Recommended Action Check the error message log on the other switch using the errShow command for additional messages. Check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or SFP if necessary. Run the portLogDumpPort command on both the receiving and transmitting port. Run the fabStateShow command on the transmitting switch. If the message persists, collect switch information using the supportShow command, and contact your switch service provider. Severity WARNING FCR-1055 Message , [FCR-1055], ,, INFO, , Switch with domain ID does not support backbone to edge imports. Probable Cause Indicates that a switch that does not support backbone-to-edge routing was detected in the backbone. Edge-to-edge routing will work, but backbone-to-edge routing might fail. Recommended No action is required if backbone to edge routing is not required. Otherwise replace the switch with Action one that supports backbone to edge routing. Fabric OS Message Reference 217 53-1001338-01