HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 147

Chapter BM System Messages 10 BM-1001 Message , [BM-1001], ,, ERROR, , BM protocol version in slot . Probable Cause Indicates that the firmware running on the control processor (CP) cannot communicate with the application processor (AP) blade in the indicated slot and determine the AP blade's firmware version. • The CP blade is running a later version of firmware than the AP blade. • The CP blade is running an earlier version of firmware than the AP blade. Recommended Action The problem can be corrected by changing the firmware version on either the control processor (CP) or on the application processor (AP) blade. You can modify the firmware version on the CP blade by using the firmwareDownload command. Refer to the release notes to determine whether a non-disruptive firmware download is supported between the revisions. Because the AP and CP blades cannot communicate, it is not possible to load new firmware on the AP blade. If needed, send the AP blade back to the factory for a firmware update. Severity ERROR BM-1002 Message , [BM-1002], ,, INFO, , Connection established between CP and blade in slot . Probable Cause Indicates the control processor (CP) has established a connection with the blade processor (BP) and can communicate. Recommended No action is required. Action Severity INFO BM-1003 Message Probable Cause , [BM-1003], ,FFDC, WARNING, , Failed to establish connection between CP and blade in slot . Faulting blade. Indicates the control processor (CP) could not establish a connection with the blade processor (BP) to communicate. Fabric OS Message Reference 77 53-1001338-01