HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 506

69 MS-1003 • Run the firmwareDownload command to upgrade the firmware level on the switch to a level that supports RCS. RCS is supported in Fabric OS v2.6, v3.1 and greater, and v4.1 and greater. • Wait a few minutes and try the command again. Severity INFO MS-1003 Message , [MS-1003], ,, INFO, , MS detected Unstable Fabric(). Probable Cause Indicates the management server (MS) detected an unstable fabric; the command or operation might not be successfully completed. This message is often transitory. The message string can be one of the following: • The domain is invalid for a request. • Unable to acquire the World Wide Name (WWN) for the corresponding domain. The domain number is the target domain that caused error. Recommended Action The fabric might be reconfiguring, forming, or merging. Wait for a few minutes and retry the operation. Run the fabricShow command or the secFabricShow command to verify that the number of domains matches the Management Server known domains. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity INFO MS-1004 Message , [MS-1004], ,, INFO, , MS detected ONLY 1 Domain(d=). Probable Cause Indicates the management server (MS) detected an unstable count of domains in its own local resource. Recommended Action This message is often transitory. The fabric might be reconfiguring, forming, or merging. Wait for a few minutes and retry the operation. Run the fabricShow command or the secFabricShow command to verify that the number of domains matches the Management Server known domains. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. 436 Fabric OS Message Reference 53-1001338-01