HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 133

BL-1013 7 Probable Cause Indicates that the port generated an excessive number of interrupts that might prove unrecoverable to the switch operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The bport is the blade port; this number might not correspond to a user port number. Recommended Action Make sure to capture the console output during this process. Check for a faulty cable, small form-factor pluggable (SFP), or device attached to the specified port. On a bladed switch, run the slotPowerOff and slotPowerOn commands. On a nonbladed switch, restart or power cycle the switch. If the message persists, replace the blade or the (nonbladed) switch. Severity ERROR BL-1013 Message , [BL-1013], ,, ERROR, , bport port is faulted. status=0x Port will be re-enabled in 1 minute. Probable Cause Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The bport is the blade port; this number might not correspond to a user port number. Recommended Action Make sure to capture the console output during this process. Check for a faulty cable, small form-factor pluggable (SFP), or device attached to the specified port. On a bladed switch, run the slotPowerOff and slotPowerOn commands. On a nonbladed switch, restart or power cycle the switch. If the message persists, replace the blade. Severity ERROR BL-1014 Message , [BL-1014], ,, ERROR, , bport port int. is disabled. status=0x. Probable Cause Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The bport is the blade port; this number might not correspond to a user port number. Recommended Action Make sure to capture the console output during this process. On a bladed switch, run the slotPowerOff and slotPowerOn commands. On a nonbladed switch, reboot the switch. Run the systemVerification command to determine if there is a hardware error. To run this command root access is required. Fabric OS Message Reference 63 53-1001338-01