HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 417

42 FW-1433 FW-1433 Message , [FW-1433], ,, WARNING, , Switch status change contributing factor CP: CP non-redundant. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of faulty CPs is greater than or equal to the policy set by the switchStatusPolicySet command. The CPs are non-redundant. If you power cycle a Brocade 24000 chassis in dual-domain configuration, and then reset the micro-switch of the active CP before the heartbeat is up, this will cause both CPs to come up in a non-redundant state. Recommended Action Run the firmwareShow command to verify that both CPs have compatible firmware levels. Run the firmwareDownload command to install the same level of firmware to both CPs. Replace any faulty CPs. If you reset the micro-switch (the latch on the CP blade) on the active CP before the heartbeat was up on a power cycle, and the CPs came up non-redundant, then you should reboot the CPs again to clear the problem. Severity WARNING FW-1434 Message , [FW-1434], ,, WARNING, , Switch status change contributing factor Blade: blade failures. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of blade failures is greater than or equal to the policy set by the switchStatusPolicySet command. Recommended Replace the faulty blade. Action Severity WARNING FW-1435 Message , [FW-1435], ,, WARNING, , Switch status change contributing factor Flash: usage out of range. Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the flash usage is out of range. The policy was set using the switchStatusPolicySet command. Recommended Run the supportSave command to clear out the kernel flash. Refer to the Fabric OS Command Action Reference for more information about this command. Severity WARNING Fabric OS Message Reference 347 53-1001338-01