HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 665

96 SULB-1009 TABLE 6 Status Messages and Status Codes Status Message Status Code "The original firmware has been restored successfully on Standby CP." 0x7e "Unable to restore the original firmware on Standby CP." 0x7f "Standby CP reboots." 0x80 "Standby CP failed to reboot." 0x81 "Standby CP booted up with new firmware." 0x82 "Standby CP failed to boot up with new firmware." 0x83 "There was an unexpected reboot during firmwareDownload. The command is aborted." 0x84 "Standby CP was not responding. The command is aborted." 0x85 "firmwareCommit has started on both CPs. Please use firmwareDownloadStatus and firmwareShow to see the firmware status." 0x86 "firmwareCommit has started on the local CP. Please use firmwareDownloadStatus and firmwareShow to see the firmware status." 0x87 "firmwareCommit has started on the remote CP. Please use firmwareDownloadStatus and 0x88 firmwareShow to see the firmware status." "Please use firmwareDownloadStatus and firmwareShow to see the firmware status." 0x89 "firmwareDownload command has completed successfully." 0x8a "The original firmware has been restored successfully." 0x8b "Remote CP is restoring its secondary partition." 0x8c "Local CP is restoring its secondary partition." 0x8d "Remote CP is restoring its secondary partition." 0x8e "firmwareDownload has started." 0x8f "firmwareCommit has started." 0x90 "firmwareDownload has completed successfully." 0x91 "firmwareCommit has completed successfully." 0x92 "firmwareCommit has started to restore the secondary partition." 0x93 "firmwareCommit failed." 0x94 "The secondary partition has been restored successfully." 0x95 "Firmware is being downloaded to the blade. This step may take up to 10 minutes." 0xa0 "firmwareDownload timed out." 0xa1 "Reboot occurred during firmwareDownload. firmwareCommit will be started to recover the 0xa2 blade." "Blade rebooted during firmwareCommit. The operation will be restarted." 0xa3 "Firmware has been downloaded successfully. Blade is rebooting with the new firmware." 0xa4 "Blade has rebooted successfully." 0xa5 "New firmware failed to boot up. Please retry firmwareDownload." 0xa6 "firmwareCommit has started on the blade. This may take up to 10 minutes." 0xa7 Fabric OS Message Reference 595 53-1001338-01