HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 139

BL-1030 7 BL-1030 Message , [BL-1030], ,, INFO, , All GigE/FCIP Virtualization/FC Fastwrite ports on the switch will be reset as part of the firmware upgrade. Probable Cause Indicates that a recent firmware upgrade caused the switch's internal processor firmware to be upgraded and resulted in the cold upgrade. As part of the upgrade, all the GbE or Fibre Channel over IP (FCIP) or Virtualization data elements or FC Fastwrite ports were reset. Recommended No action is required. Action Severity INFO BL-1031 Message , [BL-1031], ,, CRITICAL, , Link timeout in internal port (slot , port ) resulted in blade fault. Use slotpoweroff/slotpoweron to recover the blade. Probable Cause Indicates that link timeout occurred in one of the backend internal ports. Recommended Power cycle the blade or run the slotPowerOff and slotPowerOn commands. Action Severity CRITICAL BL-1032 Message , [BL-1032], ,, CRITICAL, , (slot ,bitmap 0x) ports never came up ONLINE (reason , state ). Disabling slot. Probable Cause Indicates that back-end (non-user) ports have not come ONLINE within time limit. Recommended Action Restart or power cycle the blade. Run the systemVerification command to verify that the blade does not have hardware problems. To run this command root access is required. Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. If the message persists, replace the blade. Refer to the Fabric OS Command Reference for more information on the systemVerification command. Severity CRITICAL BL-1033 Message , [BL-1033], ,, CRITICAL, , (slot ,bitmap 0x) No disable acknowledgment from ports (state ). Disabling slot. Fabric OS Message Reference 69 53-1001338-01