HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 240

26 FABR-1004 Run the fabStateShow command on both the receiving and transmitting switches. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING FABR-1004 Message , [FABR-1004], ,, WARNING, , port: , req iu: 0x, state: 0x, resp iu: 0x, state 0x, . Probable Cause Indicates that the information unit response was invalid for the specified command sent. The fabric received an unknown response. This message is rare and usually indicates a problem with the Fabric OS kernel. Recommended Action If this message is due to a one-time event because of the incoming data, the system will discard the frame. If it is due to problems with the kernel, the system will recover by performing a failover. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING FABR-1005 Message , [FABR-1005], ,, WARNING, , : port : status 0x () xid = 0x. Probable Cause Indicates that the application failed to send an async command for the specified port. The message provides additional details regarding the reason for the failure and the exchange ID of the command. This can happen if a port is about to go down. Recommended Action No action is required; this message is often transitory. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING FABR-1006 Message Probable Cause , [FABR-1006], ,, WARNING, , Node free error, caller: . Indicates that the Fabric OS is trying to free or deallocate memory space that has already been deallocated. This message is rare and usually indicates a problem with the Fabric OS. 170 Fabric OS Message Reference 53-1001338-01