HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 95

AG System Messages Chapter 2 AG-1001 Message , [AG-1001], ,, ERROR, , N_Port ID virtualization (NPIV) is not supported by fabric port connected to port . Probable Cause N_Port ID virtualization (NPIV) capability is not supported by the fabric port to which the Access Gateway is connected. Recommended Action • On switches running Fabric OS 6.0 or earlier versions, run the portCfgNpivPort command to enable NPIV capability on the port connected to the Access Gateway. Refer to the Fabric OS Command Reference manual for more information on this command. • Some blades and ports in a switch may not support NPIV. NPIV functionality can not be enabled on such ports and they will not respond to NPIV requests. Refer to the Access Gateway Administrator Guide, Appendix B, for specific AG-compatibility requirements. • On non-Brocade switches, refer to the manufacturer's documentation to determine whether the switch supports NPIV and how to enable NPIV on these types of switches. Severity ERROR AG-1002 Message , [AG-1002], ,, WARNING, , Unable to find alternate N_Port during failover for N_Port . Probable Cause Indicates no other N_Port is configured or the fabric was unstable during failover. Recommended Action Check whether or not an alternate N_Port is configured. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING AG-1003 Message , [AG-1003], ,, WARNING, , Unable to failover N_Port . Failover across different fabrics is not supported. Probable Cause Indicates that the failover does not get blocked between two fabrics, although it is not a supported configuration. Recommended Configure two or more N_Ports to connect to the same fabric; then execute the ag --failoverenable Action command to enable failover on these N_Ports. Fabric OS Message Reference 25 53-1001338-01