HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 290

34 FCR-1063 Probable Cause Indicates that the maximum number of supported EX_ports or VEX_ports was exceeded. To enable the specified port, disable any other operational port then re-enable the port. Recommended No action is required. Action Severity INFO FCR-1063 Message , [FCR-1063], ,, INFO, , Fabric for switch with domain ID: mismatch with local fabric ID . Probable Cause Indicates that the fabric ID of the switch does not match the local switch. Recommended Run the switchShow command to display the fabric ID. Change the fabric ID to match on both ends Action by modifying either the local or remote host using the fcrConfigure command. Severity INFO FCR-1064 Message , [FCR-1064], ,, ERROR, , Fabric ID of backbone FC-Routers mismatch or overlap. Probable Cause Indicates that either (1) a backbone fabric split and both are connected to common edge fabrics, or (2) the fabric IDs of two backbone fabrics connected to an edge fabric are the same. Recommended Action If the backbone fabric split, merge the fabrics. If two (or more) backbone fabrics have the same IDs, make the fabric IDs unique using fcrConfigure command. Severity ERROR FCR-1065 Message , [FCR-1065], ,, ERROR, , Fabric on port was assigned two different fabric IDs. Probable Cause Indicates that another port on the switch is connected to the same edge fabric with a different fabric ID assignment. Recommended Change the port fabric ID to same value as the other ports connected to the edge fabric using the Action portCfgExport or portCfgVexport commands. Severity ERROR 220 Fabric OS Message Reference 53-1001338-01