HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 554

83 RCS-1004 RCS-1004 Message , [RCS-1004], ,, ERROR, , Application() not registered.() Probable Cause Indicates that a specified application did not register with RCS. Recommended Action Run the haShow command to view the HA state. Run the haDisable and the haEnable commands. Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS v2.6, v3.1 and later, and v4.1 and later. Run the firmwareDownload command to upgrade the firmware for any switches that do not support RCS. Severity ERROR RCS-1005 Message , [RCS-1005], ,, INFO, , Phase , Application returned , 0x. Probable Cause Indicates that a receiving switch is rejecting an RCS phase. Recommended Action If the reject is in ACA phase, wait for a few minutes and then retry the operation from the sender switch. If the reject is in the SFC phase, check if the application license exists for the local domain and if the application data is compatible. Severity INFO RCS-1006 Message , [RCS-1006], ,, INFO, , State , Application AD, RCS CM. Domain returned 0x. App Response Code Probable Cause Indicates that a remote domain rejected an RCS phase initiated by an application on the local switch. If the reject phase is ACA, the remote domain might be busy and could not process the new request. If the reject phase is SFC, the data sent by the application might not be compatible or the domain does not have the license to support that application. Recommended Action If the reject is in ACA phase, wait for a few minutes and then retry the operation. If the reject is in the SFC phase, check if the application license exists for the remote domain and if the application data is compatible. 484 Fabric OS Message Reference 53-1001338-01