HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 433
HAM System Messages
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 433 highlights
Chapter HAM System Messages 43 HAM-1001 Message , [HAM-1001], , SLOT cp-slpt-number | FFDC | CHASSIS, FFDC, CRITICAL, , Standby CP is not healthy, device status BAD, Severity = Probable Cause Indicates that a standby control processor (CP) device error is reported by the high-availability manager (HAM) Health Monitor, with a specific device and Log="YES" Class="NONE" Severity level. The severity level can be "critical", "major", or "minor". The active CP will continue to function normally, but because the standby CP is not healthy, non-disruptive failover is not possible. Recommended Reboot the standby CP blade by ejecting the card and reseating it. If the problem persists, replace Action the standby CP. Run the supportSave command and contact your switch service provider. Severity CRITICAL HAM-1002 Message , [HAM-1002], , SLOT cp-slot-number | CHASSIS, INFO, , Standby CP is healthy. Probable Cause Indicates that all of the standby control processor (CP) devices monitored by the high-availability manager (HAM) Health Monitor report no error. Recommended No action is required. Action Severity INFO HAM-1004 Message Probable Cause , [HAM-1004], , SLOT cp-slot-number | CHASSIS, INFO, , Processor rebooted - . Indicates the system has been rebooted either because of a user action or an error. The switch reboot can be initiated by the firmwareDownload, fastBoot, haFailover, and reboot commands. Some examples of errors that might initiate this message are hardware errors, software errors, compact flash errors, or memory errors. The reboot reasons can be any of the following: • Hafailover • Unknown Fabric OS Message Reference 363 53-1001338-01