HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 667

96 SULB-1009 TABLE 7 Error Messages and Error Codes Error Message Error Code "firmwareDownload timed out." 0x23 "Our of disk space." 0x24 "Primary filesystem is inconsistent. Run firmwareRestore to restore the original firmware, or contact your service provider for recovery." 0x25 "The post-install script failed." 0x26 "Unexpected reboot." 0x27 "Primary kernel partition is inconsistent. Please contact your service provider for recovery." 0x28 "The pre-install script failed." 0x29 "The platform option is not supported. Run chassisConfig to reset the option first and then try 0x2a firmwareDownload." "Failed to install RPM package." 0x2b "Cannot downgrade directly to this version. Downgrade to an intermediate version first and then 0x2c download the desired version." "Cannot download 5.1 because Device Based Routing policy is not supported by 5.1. Use aptPolicy to change the routing policy before proceeding." 0x2d "Invalid RPM package. Please reload firmware packages on the file server." 0x2e "Cannot downgrade due to presence of blade type 17. Remove or power off these blades before 0x2f proceeding." "Cannot downgrade due to presence of blade type 24. Remove or power off these blades before 0x30 " "Cannot downgrade due to presence of long-distance ports in LS mode. Please remove these 0x31 settings before proceeding." "Network is not reachable. Please verify the IP address of the server is correct." 0x32 The following section explains the causes of some common error messages: 0x15 - Failed to download Red Hat package manager (RPM) package. If this error occurs immediately after firmwareDownload is started, the firmware on the switch may be two releases older than the requested firmware. firmwareDownload supports firmware upgrades within two feature releases (a feature release is indicated by a major number and a minor number, for example, X.Y). The following are major upgrade versions for the Fabric OS: v4.0, v4.1, v4.2, v4.4, v5.0, v5.1.,5.2, and 5.3. In this case, you will need to upgrade to an intermediate version before downloading the desired version. If this error occurs in the middle of firmwareDownload, the firmware in the file server may be corrupted or there may be a temporary network issue. In this case, retry the firmwareDownload command. If the problem persists, contact your system administrator. 0x18 - Error in getting lock device for firmwareDownload. This error may occur because another firmwareDownload is already in progress. Run firmwareDownloadStatus to verify that this is the case. Wait for the current session to finish before proceeding. 0x23 - firmwareDownload timed out. This error may occur because firmwareDownload has not completed within the predefined timeout period. It is most often caused by network issues. If the problem persists, contact your system administrator. Fabric OS Message Reference 597 53-1001338-01