HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 584

90 SEC-1076 Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1076 Message , [SEC-1076], ,, ERROR, , NoNodeWWNZoning option has been changed. Probable Cause Indicates the NoNodeWWNZoning option has been changed. If the option is turned on, a zone member can be added using node WWNs, but the member will not be able to communicate with others nodes in the zone. Recommended Re-enable the current zone configuration for the change to take effect. Action Severity ERROR SEC-1077 Message , [SEC-1077], ,, ERROR, , Failed to activate new policy set on all switches. Probable Cause Indicates the policy could not be activated. Possible reasons that the policy could not be activated include not enough memory or a busy switch. Recommended Run the secFabricShow command to verify that all switches in the fabric are in the ready state. Action Retry the command when all switches are ready. Severity ERROR SEC-1078 Message , [SEC-1078], ,, ERROR, , No new data to abort. Probable Cause Indicates there are no new changes in the defined security policy database that can be aborted. Recommended Verify the security event was planned. Verify if there were really any changes to the defined policy Action database that can be aborted. Severity ERROR 514 Fabric OS Message Reference 53-1001338-01