HP StorageWorks 1606 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 600

90 SEC-1153 Probable Cause Indicates the PID format of the switch was changed either to extended-edge PID or from extended-edge PID. If the device connection control (DCC) polices existed, all index/area ID values either increased or decreased by 16. The values wrap around after 128. If a DCC policy contains an index/area of 127 before changing to extended-edge PID, then the new index/area is 15, because of the wraparound. Recommended No action is required. Action Severity INFO SEC-1153 Message , [SEC-1153], ,, INFO, , Error in RCA: RCS is not supported Probable Cause Indicates that reliable commit service (RCS) is not supported. Recommended Action Run the rcsInfoShow command to view RCS capability on the fabric. RCS must be capable on all switches in the fabric to be enabled. If all switches are capable, it is automatically enabled. For any switch that does not support RCS, obtain the latest firmware version from your switch supplier, and run the firmwareDownload command to upgrade the firmware. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity INFO SEC-1154 Message , [SEC-1154], ,, INFO, , PID change failed: . Probable Cause Indicates that either the defined or the active policy could not be updated. If the policy database is very large, it might not be able to change the index/area because the new policy database exceeds the maximum size. This message can also be caused when the switch is short of memory. The status values can be either defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Reduce the size of the policy database. Action Severity INFO SEC-1155 Message , [SEC-1155], ,, INFO, , PID change failed: . 530 Fabric OS Message Reference 53-1001338-01