HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 156
TABLE 5, Zoning Operation Parameters, RSCN Transmission Mode, Arbitrated Loop Parameters
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
2 configure Note that the maximum logins per port parameter can be configured only for external ports. Zoning Operation Parameters Table 5 lists the configurable zoning operation parameters. TABLE 5 Zoning operation parameters Field Type Default Range Disable NodeName Zone Boolean 0 1 Checking Disable NodeName Zone Checking Specify 1 to disable using node WWN when specifying nodes in the zone database, or specify 0 to enable using node WWN when specifying nodes in the zone data. The default value is 0. This value must be set to 1 for interpretability. RSCN Transmission Mode Table 6 lists the RSCN transmission mode values fields. TABLE 6 RSCN transmission modes Field End-device RSCN Transmission Mode Domain RSCN to End-device for switch IP address or name change Type number number Default 1 0 Range 0 to 2 0 to 1 End-device RSCN Transmission Mode values are as follows: 0 RSCN only contains single PID 1 RSCN contains multiple PIDs 2 Fabric addresses RSCN Domain RSCN to End-device for switch IP address or name change values are as follows: 0 Disabled. No domain RSCN is sent to the end-device for the switch IP address or name change. 1 Enabled. Domain RSCN is sent to the end-device for the switch IP address or name change. Arbitrated Loop Parameters The Arbitrated Loop Setting fields are described in Table 7. TABLE 7 Configure command arbitrated loop settings Field Default Send FAN frames? 1 Enable CLOSE on OPEN received? 4 Always send RSCN? 0 Range 0 or 1 0 to 4 0 or 1 126 Fabric OS Command Reference 53-1001337-01