HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 637

portCfgFillword 2 portCfgFillword Synopsis Configures the fill word for a single 8G FC port. portcfgfillword [slotnumber/]portnumber, mode portcfgfillword --help Description Use this command to configure the fill word of an 8G FC port. This command is not applicable to non-8G FC ports. This command disables and re-enables the port and the port comes online with the new fill word setting. The configuration is stored in nonvolatile memory and is persistent across switch reboots or power cycles. Notes This configuration cannot be set on VE_Ports or VEX_Ports. Use the portCfgShow command to display user-configured fill word settings. The execution of this command is subject to Admin Domain or Virtual Fabric restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: slotnumber For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). portnumber Specifies the number of the port to be configured, relative to its slot for bladed systems. Use switchShow for a listing of valid ports. mode Specifies the fill word for the port number. This operand is required. Valid values are one of the following: 0 |-idle-idle Sets IDLE mode in the Link Init and IDLE as the fill word (default). 1 | -arbff-arbff Sets ARB(ff) in the Link Init and ARB(ff) as the fill word. Examples To set the fill word of a port to ARBFF-ARBFF using the numeric mode notation: switch:admin> portcfgfillword 2/3, 1 To set the fill word of a port to ARBFF-ARBFF using the -arbff-arbff option: switch:admin> portcfgfillword 2/3, -arbff-arbff See Also portCfgShow Fabric OS Command Reference 607 53-1001337-01