HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 186

2 cryptoCfg - Block size: numeric value (in KB) - Size of the LUN (in bytes) - Current logical block address (LBA) being processed - Re-Key Role: Primary Or Backup Use the --show -tape_sessions command to display all tape sessions in progress on the local node or for a specific container. The display includes the following information: • Number of tape sessions in progress: numeric value • Container name: user-defined label • EE node name: node WWN • EE Slot Number: slot number • Target: target port WWN and node WWN • Target PID: Target PID • VT: virtual target port WWN and node WWN • VT PID: virtual target PID • Host: host port WWN and node WWN • Host PID: host PID • VI: virtual initiator port WWN and node WWN • VI PID: virtual initiator PID • LUN number: numeric identifier • Tape session number: numeric identifier • For each Tape session: - Number of uncompressed blocks: numeric value - Number of compressed blocks: numeric value - Number of uncompressed bytes: numeric value - Number of compressed bytes: numeric value Notes Encryption groups and HA clusters must be configured before performing any CryptoTarget container and Crypto LUN configurations. When adding a LUN to a CryptoTarget container, special attention should be paid to the input format. A LUN number can be entered either as a 16-bit (2 bytes) number in hex notation (for example, 0x07) or as a 64-bit (8 bytes) number in WWN format (for example, 00:07:00:00:00:00:00:00). Although the command does accept decimal input, it is not recommended. The conversion function used to parse the LUN number converts a decimal number beginning with 0 to an octal, which results in a conversion error. For example, 035 is interpreted as 29 (decimal), or 0x1D hex, or 00:1D:00:00:00:00:00:00. To ensure correct conversion to decimal notation, use the recommended Hex formats or make sure to remove preceding zeros from decimal input. Operands The cryptoCfg storage device configuration and management function has the following operands: --help -devicecfg Displays the synopsis for the storage device configuration and management function. This command is valid on all nodes. 156 Fabric OS Command Reference 53-1001337-01