HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 888

2 switchShow FICON Persistent DID This port has been disabled, because the switch could not obtain its configuration domain ID during the fabric reconfiguration when ficonMode was enabled. See the ficonMode help page for more information. Fabric ID conflict Two different fabrics have been assigned the same fabric ID (EX_Ports only). Fabric ID oversubscribed One fabric has been assigned two different fabric IDs (EX_Ports only). AoQ Indicates that the F_Port has negotiated a link that is capable of quality of service (QoS). (logical) Indicates a logical port. The switchshow output shows all logical ports currently present in the logical switch. The command displays -1 for the slot for logical ports and the user port number for slot port. The logical port numbers are not persistent and may change when the logical interswitch links (LISLs) are deleted and recreated. A logical port is shown to be in one of the following states: E_Port (if the port is online), offline, or disabled. When the port is disabled, a reason is provided. When used with the -slot option, the command displays the following blade-specific information: slot Slot number. Blade Type Type of blade, for example, Core blade or AP blade. Refer to the slotShow command for a listing of supported blade types. ID A numeric blade ID that specifies the blade type. Refer to the slotShow command for a listing of supported blade IDs. Status Enabled or disabled. Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. On the Brocade 8000, the Proto column identifies the FCoE ports of the switch. For all FcoE ports, the speed is 10 Gbps. The default configuration of an FCoE port is an F_Port configuration. After a successful reboot switchShow displays all FCoE ports as online. For each FCoE port, the FCoE controller WWN is shown. FCoE ports are not configurable with the Fabric OS port commands. Use the fcoe commands instead. If a port is configured as a long distance port, the long distance level is displayed in the format of Lx, where x represents the long distance level number. See portCfgLongDistance for the level description. The port state for disabled E_Ports displays as In_Sync when the port is the interswitch link (ISL) between a Brocade 48000 and a Brocade 24000. If the ISL is between a Brocade 48000 and a Brocade 4100 or 200E, the disabled E_Port displays as No_Sync. On a Brocade 7600 switch, if the SAS image is not consistent with the FOS image, the message "SAS Virtualization Disabled" is displayed. When a port is configured as an N_Port and is online, switchShow displays its type as an N_Port. Also, switchShow displays the WWN of the border switch attached to this N_Port as a 24-bit Port Identifier assigned to this port by the enterprise fabric. 858 Fabric OS Command Reference 53-1001337-01