HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 831

setModem 2 setModem Enables or disables modem dial-in to a control processor (CP). Synopsis setmodem [-e] | [-d] Description Use this command to enable or disable modem dial-in to a CP on those systems that support modem dial-in. When modem dial-in is enabled, you can log in to a CP through a modem, and a modem attached to the CP accepts the call. When modem dial-in is disabled, the modem attached to the CP does not accept the call. When entered with no operands, the command displays the current state of the modem dial-in. Modem dial-in must be through an Hayes-compatible modem attached to a CP modem serial port. When the CP is active and dial-in is enabled, the modem is configured to answer an incoming call on the first ring. When the CP is standby and dial-in is enabled, the modem is configured to answer an incoming call on the seventh ring. In the recommended configuration, a separate modem is connected to each modem port of CP0 and CP1. These modems connect to the telephone outlet through an RJ-11 Y-adapter and standard telephone wire is attached to the wall outlet. During an incoming call, both modems ring and the one connected to the active CP answers the call first. If for any reason the active modem fails to answer, the caller is logged in to the standby CP. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. This command is not supported on the Brocade DCX backbone. Operands The optional operands are as follows: -e Enables modem dial-in. -d Disables modem dial-in. Examples To disable modem dial-in to a CP: switch:admin> setmodem -d disabling modem, please wait, this can take a couple of minutes... modem disabled See Also none Fabric OS Command Reference 801 53-1001337-01