HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 881

switchCfgTrunk 2 switchCfgTrunk Synopsis Enables or disables trunking on all the ports of a switch. switchcfgtrunk mode Description Use this command to enable or disable trunking on all the ports of a switch. Use portCfgTrunkPort to enable or disable trunking on a single port. When the command is executed to update the trunking configuration, the ports to which the configuration applies are disabled and subsequently re-enabled with the new trunking configuration. Traffic through these ports may be temporarily disrupted. The command issues a message that lists the VE/VEX_Ports to which the configuration does not apply. Trunking on Inter-Chassis Link (ICL) ports is always enabled and cannot be turned off by this command. Disabling trunking fails if a Trunk Area (TA) is enabled on the port. Use the portTrunkArea command to disable the TA on all ports before disabling trunking. Notes Enabling trunking requires an ISL Trunking license. You may disable trunking without a license. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands The following operand is required: mode Specify 1 to enable trunking on all ports. Specify 0 to disable trunking on all ports. Examples To enable trunking on all ports of a switch: switch:admin> switchcfgtrunk 1 Configuration applied to all ports except the following \ VE/VEX_Ports (ports 176 - 191). See Also To disable trunking on all ports of a switch: switch:admin> switchcfgtrunk 0 Committing configuration...done. portCfgShow, portCfgTrunkPort, portShow, portTrunkArea, switchShow Fabric OS Command Reference 851 53-1001337-01