HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 281

fcpRlsShow 2 fcpRlsShow Synopsis Displays the Fibre Channel Protocol (FCP) Read Link Status (RLS) information. fcprlsshow [slotnumber/]portnumber Description Use this command to display the FCP RLS information for an F_Port or FL_Port. This information describes the number of loss-of-signal, loss-of-sync, CRC errors, and other failure events that have been detected on the specified port. For this command to gather and display F_Port error statistics, you must enable the following two configuration parameters: • Disable Device Probing = Enabled 1 • Disable RLS Probing = Enabled 1 Device probing and RLS probing are disabled by default. Use the configure command to enable these parameters. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: slotnumber For bladed systems only, specifies the slot number of the port to display, followed by a slash (/). portnumber Specifies the port number to display, relative to its slot for bladed systems. Use switchShow for a listing of valid ports. This operand is required. Examples To display the FCP RLS information: switch:admin> fcprlsshow 2/5 0xda 0xdc link fail 0 0 loss sync 5 3 loss sig 0 0 prtc err 0 0 bad word 525 330 crc err 0 0 See Also portLoginShow, portLogShow Fabric OS Command Reference 251 53-1001337-01