HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 88

2 bladeCfgGeMode bladeCfgGeMode Synopsis Configures a 1 GbE port or a 10 GbE port on the Brocade FX8-24 blade. bladecfggemode --set mode -slot slot_number bladecfggemode --show -slot slot_number | -all bladecfggemode --help Description Use this command to configure the GbE port mode on the Brocade FX8-24 extension blade or to display the configuration. The mode configuration controls which ports are enabled. Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. This command is supported only on the Brocade FX8-24 blade in a DCX or DCX-S4 chassis. Operands This command has the following operands: --set mode Sets the GbE port mode for a specified slot. Valid modes are one of the following: 1g Enables the GbE ports ge0-ge9 (xge0 and xge1 are disabled). 10g Enables the GbE ports xge0 and xge1 (ge0-ge9 ports are disabled). dual Enables the GbE ports ge0-ge9 and xge0 (xge1 is disabled). -slot slot_number Specifies the slot number for the FX8-24 blade. This operand is required when setting the GbE port mode. --show Displays the GbE port mode for a specified slot. -slot slot_number Displays the GbE port mode for the specified slot. -all Displays the GbE port mode for all configured slots. --help Displays the command usage. Examples To configure the Brocade FX8-24 blade in slot 4 in 1G mode: switch:admin> bladecfggemode --set 1g -slot 4 switch:admin> To display the GbE port mode for the Brocade FX8-24 blade in slot 4: switch:admin> bladecfggemode --show -slot 4 bladeCfgGeMode: Blade in slot 4 is configured in 10GigE Mode 10GigE mode: only xge0 and xge1 are enabled (ge0-9 ports are disabled) switch:admin> 58 Fabric OS Command Reference 53-1001337-01