HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 78

2 auditCfg auditCfg Synopsis Modifies and displays the audit log filter configuration. auditcfg --class audit_class auditcfg --enable |--disable auditcfg --severity severity_level auditcfg --show Description Use this command to configure the audit logging and to display the audit log configuration. This command allows you to set filters by configuring certain classes, to add or remove any of the classes in the filter list, to set severity levels for audit messages, and to enable or disable audit filters. Based on the configuration, certain classes are logged to syslog for auditing. Syslog configuration is required for logging audit messages. Use the syslogdIpAdd command to add the syslogd server IP address. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: --class audit_class Configures filters for a specified audit class. To add or remove any of the classes in the filter list, re-issue the --class option. Specifies the filters to be configured. Valid values are: 1-ZONE, 2-SECURITY, 3-CONFIGURATION, 4-FIRMWARE and 5-FABRIC filters. This operand is required. --severity severity_level Sets audit severity level. When severity is set, only log messages of type severity_level and higher are displayed. Valid values are INFO, WARNING, ERROR, and CRITICAL. By default, all messages are logged. This operand is required. --enable Enables all filters. --disable Disables all filters. --show Displays the current configuration. This operand is optional. Examples To configure the audit log filter, disable audit logging, and show the configuration: switch:admin> auditcfg --class 2,3 Audit filter is configured. switch:admin> auditcfg --disable Audit filter is disabled. 48 Fabric OS Command Reference 53-1001337-01