HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 846

2 SnmpConfig In Fabric OS 6.3.0 and later, the --set snmpv3 command supports an interactive option to enable or disable informs by setting the parameter "SNMP Informs Enabled" to true or false. If informs are enabled, all trap destinations receive inform requests. If informs are disabled, all trap destinations receive trap requests. When informs are enabled, the engine ID must be set to correspond to the management engine IP address (see example). Informs are by default disabled. IPv6 Informs are currently not supported. accessControl Selects access-control-related parameters. These parameters include the access host subnet area and access permission (read-write). mibCapability Selects configuration parameters related to the SNMP agent's MIBs and trap capability parameters. These parameters include MIBs and traps supported by the SNMP agent. systemGroup Selects configuration parameters related to the system group. These parameters include sysDescr, sysLocation, sysContact, and authentication failure trap. secLevel Sets the SNMP security level. SNMPv1 Configuration Parameters The agent supports six communities and their associated trap recipients and trap recipient severity levels. The first three communities are for read-write (rw) access and the last three are for read-only (ro) access. The default value for the trap recipient of each community is 0.0.0.0. The length of the community string should be in the range of 2 to 16 characters. The default values for the community strings are: Community 1: Secret Code Community 2: OrigEquipMfr Community 3: private Community 4: public Community 5: common Community 6: FibreChannel When an FCS policy s enabled, community strings can be changed on the primary FCS switch only, and only the primary FCS switch propagates changes across the fabric. For an SNMP management station to receive a trap generated by the agent, the administrator must configure a trap recipient to correspond to the IP address of the management station. In addition, the trap recipient must be able to pass the access control list (ACL) check as described in the Access Control category. Trap Recipient Severity Level When an event occurs and its severity level is at or below the set value, the Event Trap traps (swEventTrap, connUnitEventTrap and swFabricWatchTrap), are sent to configured trap recipients. By default, this value is set at 0, implying that no Event Trap is sent. Possible values are 0 None 1 Critical 816 Fabric OS Command Reference 53-1001337-01