HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 620

2 portCfg 590 -p Control L2 CoS Specifies the pL2_Class_of_Service/Priority for the FCIP control connection as defined in the IEEE 802.1p specification. The range is 0-7. The default is 0. -P L2 CoS Specifies the PL2 Class of Service/Priority for the FCIP data connection as defined in the IEEE 802.1p specification. The range is 0-7. The default is 0. -bstr 0|1 Enables (1) or disables (0) Byte Streaming on the specified tunnel. Byte streaming allows the Brocade switch to communicate with third party WAN optimization hardware. The WAN optimization hardware connects on the GbE ports configured for FCIP. -ipsec policy _ID Specifies the Internet Protocol security (IPSec) policy number to be used on the specified tunnel. This option must be used together with -ike and -key. -ike policy_ID Specifies the Internet Key Exchange (IKE) policy number to be used on the specified tunnel. This option must be used together with -ipsec and -key. -key preshared_key Specifies the preshared key to be used during IKE authentication. Specify a double-quoted string of alphanumeric characters between 12 and 32 bytes in length. This argument must be used together with -ike and -ipsec. -b comm_rate NOTE: Only a single IPSec-enabled tunnel can be configured on a port. No other tunnels (IPSec or otherwise) can be configured on the same port. Jumbo frames are not supported on secure tunnels. Only a single route is supported on an interface with a secure tunnel. Modifies the committed traffic rate on the FCIP tunnel in Kbps. Valid range is 1,544 to 1,000,000. Specify 0 for an uncommitted tunnel. Uncommitted tunnels compete for bandwidth. Changing the comm_rate is potentially disruptive. This operand is valid only with the fciptunnel modify command. qosmap Modifies (or resets to default), the VC to QoS mapping for a particular FCIP tunnel. This table can be modified at any time without bringing down the tunnel. The FCIP tunnel must be configured with the fciptunnel create/modify -M option before the actual mapping occurs. tunnel_id The following operands are supported with the fciptunnel qosmap option: Specifies the tunnel ID. The valid range is 0-7. -default Resets or sets the VC QoS map to default values. -delete vc_num Deletes the associated QoS map configuration file. You must delete QoS mappings before downgrading to pre-v6.0.0 firmware versions that do not support QoS mapping. This command removes the file from the configuration flash memory only. The file is automatically reset to defaults if later used or modified. When modifying the VC QoS map, specifies the virtual channel ID for which the QoS map is modified. Valid values are 0 - 15. Fabric OS Command Reference 53-1001337-01