HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 632

2 portCfgDefault portCfgDefault Synopsis Restores the port configuration to factory default values. portcfgdefault [slot/][ge]port Description Use this command to reset any special port configuration values to their factory defaults. This command persistently disables ports capable of routing, which is the factory default value. You can view the current port configuration using the portCfgShow command. This command does not change the state of a port. To bring an E_Port go back online state, use either switchDisable/switchEnable or portDisable/portEnable. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. The Fabric OS port configuration commands are not supported on FCoE ports. Use fcoe --cfg to configure FCoE ports. Operands This command has the following operands: slot For bladed systems only, specify the slot number of the port to be reset to default, followed by a slash (/). port Specify the number of the port to be reset to default, relative to its slot for bladed systems. Use switchShow to list valid ports. Examples To reset a port to factory defaults: switch:admin> portcfgdefault 1/3 To reset a GbE port to factory defaults: switch:admin> portcfgdefault 8/ge1 See Also portCfgEport, portCfgGport, portCfgLongDistance, portCfgLport, portCfgPersistentDisable, portCfgPersistentEnable, portCfgShow, portCfgSpeed, portCfgTrunkPort 602 Fabric OS Command Reference 53-1001337-01