HP StorageWorks 1606 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 428

2 ipAddrShow • stateless - Acquired through stateless auto configuration. IP Address state: • tentative • preferred • deprecated Refer to the RFC 2462 specification for more information. On modular platforms with intelligent blades, the addresses configured for each slot can be shown with the -slot option. On standalone platforms, all command options are ignored. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: -cp cp_number On dual-CP systems, specifies the CP card number to be displayed (0 or 1). -chassis On dual-CP systems, displays the IP addresses for the chassis. -slot slot_number Specifies the slot for a blade. -eth0 |-eth1 |-gate For a specified slot, shows only the selected Ethernet interface or the gateway . This operand is optional with the -slot option. Examples To display the IP addresses on a standalone switch: switch:admin> ipaddrshow SWITCH Ethernet IP Address: 192.168.163.238 Ethernet Subnetmask: 255.255.255.0 Gateway IP Address: 192.168.163.1 DHCP: Off IPv6 Autoconfiguration Enabled: No Local IPv6 Addresses: static 1080::8:800:200c:417a/64 To display all IP addresses on a Brocade DCX backbone: switch:admin> ipaddrshow Chassis Ethernet IP Address: 10.33.60.85 Ethernet Subnetmask: 255.255.240.0 CP0 Ethernet IP Address: 10.33.60.86 Ethernet Subnetmask: 255.255.240.0 Host Name: cp0 Gateway IP Address: 10.33.48.1 CP1 Ethernet IP Address: 10.33.60.87 Ethernet Subnetmask: 255.255.240.0 Host Name: cp1 Gateway IP Address: 10.33.48.1 398 Fabric OS Command Reference 53-1001337-01